Category:
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
0
1
2
3
4
5
6
7
8
9
Position:IcFull.com » IC Electronic information » Category: S

IC Electronic information

Sound engineering how much should be configured in the loudspeaker system

In Electronic Infomation Category: S | on April 27,2011

High-quality speaker system to re-release of a variety of music programs, then according to the properties of music signals, the peak factor of about 10-15DB, to ensure quality from this perspective, this dynamic range amplifier should be of no limiting cases in which the maximum output power of amplifier loudspeaker should be 5-8 times the rated power, this power configuration despite the good quality, but his investment will be very large, so generally the ratio of the power set at 1 - 2 times the rated power of the speaker unit.

Following is a general configuration of audio engineering experience

1, the lower the investment required in a limited number of projects, the power amplifier rated at least equivalent to the speaker. Great attention to maintaining the sound but not distorted. Power allocation is too small will not damage the speaker unit looks, it is not. The power is too small clipping overload can easily occur, resulting in a large number of harmonics, burned tweeter.

2, general engineering recommended amplifier power is 1.5 times. The bass part, preferably more than 1.5 times, in order to get enough sense of power.

3, demanding venues such as recording studio *, concert halls, the ideal is twice the horse power speaker. (This is with the International Electrotechnical Commission IEC standard developed by matching the value of a program recommended by the same).

In short, the design of amplifier power is no rigid standards, fully depends on the quality of the investment budget and MAX506BCPP datasheet and requirements.

MAX506BCPP datasheetMAX506BCPP suppliersMAX506BCPP Price

Related technical information

All right reserved:icfull.com © 2010-2016 Certificate