Category:
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
0
1
2
3
4
5
6
7
8
9
Position:IcFull.com » IC Electronic information » Category: M

IC Electronic information

Maintenance of digital cinema projectors and debugging (c)

In Electronic Infomation Category: M | on April 18,2011

Eight basic use of the touch screen

Basically the operation of the projector on the touch screen, so it is very common piece of content.

You are already familiar lights, brake light switch, channel switch operation is no longer introduced here briefly introduce a few other menu, then enter the engineers menu to specific debugging.

1, open test pattern (Figure 14)


Figure 14

Directly on the map right click on the icon to the output test pattern, easy to diagnose the causes abnormal image.

2, view the situation in light of information and SB3053P-T6 datasheet and click on the map lamp power the service, you can open the following menu, and SB3053P-T6 price and adjust the current (Figure 15).


Figure 15

In the absence of lights, they also can adjust the lamp current parameters, note that this number is not the actual lamp current value, but a regulatory parameter. The figure we can see the light of the actual power, light engineers need to enter the actual current mode (see IX, Advanced use of the touch screen), the right of navigation on the touch screen Click the "Install" "light" "light output", it can be seen to.

IX, Advanced use of the touch screen

Into the technician model in Figure 16.


Figure 16

Steps: Click on the map in the lower left corner

little man icon (1), then click the icon that pops up (2a) of the Service TechniciST, the user name to appear ST (2b), enter the password "xxxxxx" (3), click OK (4 ) to switch to the technician model, commonly used lens correction and SB3053P-T6 suppliers and image trimming and other senior operations need be carried out in the technician mode.

1, create a clone image file

DP2000 unique cloning operation, set the parameters of the film made of paper machine to clone and recover, the operation is very simple and effective.

Steps:

Click on the right side of the touch screen navigation menu to install Advanced, and then click on "being cloned"

Election "under the projector to create a clone file," click NEXT (Figure 17).


Figure 17

In Figure 18, click on the "default clone" (2).


Figure 18

Click on the "clone set specific settings" before: "mouth" (3), pop-up "to set specific options" small frame, choose "Yes", enter the interface of Figure 19.


Figure 19

Click NEXT (Figure 19) select Change. Figure 20 (4) (5).


Figure 20

Choose U disk, there can also be directly on the touch screen (6a) (6b), direct point determination (7) (8) (9), then "create a clone file", (10) projector will be his own All settings (except the lens file) is stored in the built-in touch screen computer (recommended to save a file as a backup machine.)

2, application of clone file

Steps:

Figure 21, select "clone file to the projector" (1) Click to select (2) click on the file you save the address of clones (3a) (3b) find the file (4) OK (5 ) Click "Apply clone file" (6).


Figure 21 Admitted to the clone file

projector in the middle pop-up prompt appears generally choose "Yes" or "OK."

Clone file operations in general replacement of electronic box drawers have to do, thus reducing the re-commissioning of the step change, but the lens of the LENS file needs to be readjusted.

SB3053P-T6 datasheetSB3053P-T6 suppliersSB3053P-T6 Price

All right reserved:icfull.com © 2010-2016 Certificate